Precision

Magnum Companies continually strives to supply our customers with the highest quality products they require. We will meet or exceed the needs of our customers both in quality and reliability. Magnum Companies will adhear to all customers specifications in fabrication of their products per the customer supplied blueprints. Should a question or conflict arise during the fabrication process, Magnum will make every attempt to work with its customer to correct the issue. IF there is no solution to any issue or conflict pertaining to the fabrication process, Magnum will refer to in-house standards as follows:

Magnum Companies In House Quality Standard

Forming tolerances for all materials.... +/-.030 non-stacking

90 degree flange tolerance all materials. +/- 1/2 degree

Welding tolerances for all materials.... +/-.040 non-stacking

Hole tolerance for all materials........ +/-.005

Material thickness tolerance....per supplier specs.

Saw cut material tolerance...............+/-.030

Saw cut angle/bevel cuts tolerance....... +/- 1/2 degree

Visual tolerances all materials painted

Class "A"....36 inches from surface,30 seconds visual,direct light
1 flaw .005-.010 per 100 sq. inches

Class "B"....48 inches from surface,20 seconds visual,indirect light
1 flaw .010-.020 per 30 sq. inches

Class "C"....48 inches from surface,15 seconds visual,indirect light
1 flaw per 10 sq. inches

Visual tolerances all materials finished

Class "A"....12 inches from surface,30 seconds visual,direct light
1 flaw .005 per 100 sq. inches

Class "B"....48 inches from surface,20 seconds visual,indirect light
1 flaw .010 per 30 sq. inches

Class "C"....48 inches from surface,15 seconds visual,indirect light
1 flaw .020 per 10 sq. inches

All grain applied to any material will be #4 satin falling under class "B" of materials finished.

Magnum Companies is not responsible for defects under PRE-Plastic coated material purchased for fabrication purposes or customer supplied material.

All welds ground where applicable, will be finished with 120 grit media.

Magnum in-house standards are subject to review and revision at any time.